I’ve searched the past four months of the archives and reviewed the FAQs and
still can’t seem to get the SDL binaries installed correctly to support the
installation of the perl module SDL_Perl2.1.1 on a Win32 system.
A recent article at Perl.com
(http://www.perl.com/pub/a/2004/12/01/3d_engine.html) has spike my interest
exploring the use of SDL.
If anyone has had success at installing and using this combination of
software on a Win32 box, could you point me to the right documentation for
installing and configuring the software?
All of the SDL Win32 binaries have been downloaded, but I’m not sure where
to place them.
When I attempt to build the perl module, ‘perl build.pl’ it complains about
not being able to execute, ‘sdl-config’.
Merry Christmas, Craig